Seismic intensity standard for supercapacitors in solar container communication stations
Design recommendations consist of seismic criteria, qualification methods and levels, structural capacities, performance requirements for equipment operation, installation methods, and documentation. Publi 44-5486-5. . All rights including translation into other languages, reserved under the Universal Copyright Convention, the Berne Convention for the Protection of Literary and Artistic Works, and the International and Pan American Copyright Conventions. [3] The standard provides the minimum requirements that the design of an electrical substation (except. . for structures and ancillary systems including standby power systems. Such stations often contain accelerometers, seismometers and/or GPS. [PDF Version]FAQS about Seismic intensity standard for supercapacitors in solar container communication stations
What standards are used for seismic design of substations?
The two main interna tional groups of standards used for this work are IEEE 693 and IEC 61463. IEEE 693-2005, “Rec-ommended Practice for Seismic Design of Substations” is a newly revised document covering the procedures for qualification of electrical substation equip-ment for different seismic performance levels.
What is a seismic standard?
This standard is recognized also by American National Standards Institute, and is used mainly in the American Continent. The goal of the standard is to provide a single set of rules and regulations that cover the seismic design of both new and existing electrical substations, hence leading to standardization.
Do electrical generating systems need a seismic certification?
ign standards for structures and systems to withstand a seismic event. The likelihood and severity of a seismic event anywhere in the U.S. is shown in (Figure 1); however, (Figure 4) shows where in the U.S. electrical generating systems require certifica
What are the requirements for designated seismic systems?
irements for designated seismic systems on the construction documents. Each manufacturer of designated seismic system components shall test or analyze the component and its mounting system or anchorage and submit a certificate of compliance for review and acceptance by the registered design professional in responsible charge for the design of